Job Title FRONT END MAINTENANCE MECHANIC | NIGHTS 6P - 6A | 4 ON 4 OFF | $26.03 HR Plant/Location Owatonna, MN 55060 US (Primary) Job Type Hourly Category Manufacturing and Production Career Level Experienced (Non-Manager) Education No high school diploma Job Accountabilities Position Overview: The Front End Maintainers work 12-hour shifts on for four nights and off for four nights. The Front End Maintainers initiate the can making process and responsible for the set up, operation and maintenance of the cupping press, body makers, trimmers, and conveying systems. Duties And Responsibilities: Inspect, upend and load coils onto the unwinder and feed coils through lubricator and into press. Set-up, maintenance and operation of the upender, unwinder, lubricator, and cupping press. Set-up, maintenance and operation of the body makers, trimmers, and conveying systems. Inspect and monitor, then enter into computer the following can specifications: - flange wall thickness - mid-wall thickness - dome depth - trim can height Perform visual checks and cup weights to insure that process is in compliance and take appropriate measures. Assist in other areas as needed to maintain smooth can flow through the plant. Complete required paperwork and documentation such as coil log, check sheets, etc. Maintain cleanliness of all work areas and machines and practice proper safety procedures. Performs other job-related duties as required or assigned Job Requirements Working knowledge of pneumatics and hydraulics Basic knowledge of how electrical components work Abilityto use precision measurement devices (i.e. calipers, micrometers and dial indicators) Travel 0 - 10% Crown is an equal opportunity employer. Crown does not discriminate against any candidate or employee on the basis of race, national origin, sex, marital status, sexual orientation, age, disability, religion, veteran status, or any other status protected by law. EEO/AA/Vets/Disabled